GRAPHTEC CE6000 SERIES - Page 37

2-7
3 Pulled from the front, the roll media should be long enough
so that its tip completely covers the sensor. If you pull it too
long, wind the roll and adjust the length.
Push roller
Media sensor
Supplement
The media must always be positioned over
the media sensor.
See "2.4 Aligning the Push Rollers"
P.2-19
about the position of the push rollers.
4 Position the media and the push rollers to correspond with
the width of the media.
The push rollers push down on either side of the media. Use
the grit roller position guide to make sure the push rollers are
set on top of the grit rollers.
Push roller
Push roller
Grit roller
Media
Media sensor
Grit roller position guide
When Feeding Long-axis Media (at exceeds 2 meters)
Position the push rollers at least 15 mm inside the edges of
the media.
Push roller
Media
15 mm 15 mm
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 5 mm inside the edges of
the media.
Push roller
Media
5 mm 5 mm