GRAPHTEC CE6000 SERIES - Printing the Setting of the Plotter

13-14
Condition setting list can be printed when you need to check the current setting of the plotter.
CAUTION
Do not place you hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage
will start to move immediately after selecting to print the CONDITION list.
Once you start printing, pause/cancel can not be performed in the middle.
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
for loading the media.
1 Set a media larger than A3 size.
Supplement
See "Attaching a Tool"
P.2-4
for setting
the pen tool.
For changing the tool conditions please refer
to "Selecting Tool Condition"
P.2-32
, and
for tool settings please refer to "Setting the
Tool"
P.2-38
.
2 Set the pen tool to the tool holder 1 (Backward) and select
the condition where the pen tool is set.
Supplement
Perform the settings in Normal mode.
3 Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4 Press the POSITION ( ) key (TEST).
TEST menu screen (1/2) is displayed.
5 Press the [1] key (CONDITION LIST).
CONDITION LIST print screen is displa yed.
13.2
Printing the Setting of the Plotter