2-23
Turning on the power of the plotter.
Operation
1 Check that the power switch is turned off. (the " " side is
pressed down)
2 Connect one end of the provided power cord to the CE6000
AC line inlet and the other end to an electrical socket of the
rated supply voltage.
Supplement
When turning the power off, wait over 20
seconds before turning it on again, otherwise
problems may occur with the display.
3 Turn on the CE6000 by pressing the "|" side of the switch.
LCD on the control panel is lit.
Supplement
The Default Screen will appear after
purchasing the machine. See "2.5 About
the Default Screen"
P.2-22
for more
information.
This screen is described as "default screen"
in this document.
Settings such as initial media feed speed and
communication conditions can be performed.
4 If media has not been loaded, the rmware version number is
displayed, followed by a prompt to load media.
Media set lever raised
(The push roller is up)
Media set lever lowered
(The push roller is down)
2.6
Connecting to the Power
To Next Page
Loading...
