GRAPHTEC CE6000 SERIES - Page 69

2-39
Supplement
What is Offset
It will adjust the difference between the tip
of the blade in the plunger and the center of
the plunger. There are standard adjustment
values for each cutter blades. Fine
adjustment will be made to that standard
values here. (Adjustment will be made with
standard value as 0.)
It is not necessary to set the offset if "PEN",
was selected in the tool settings. (not
displayed)
Guideline to Set Offset
Blade
material/
tool
Blade type Setting
range
Setting
value for
other
Ultra-hard
blade
CB09UB ±5 19
CB15U ±5 29
CB15UB ±5 7
CB09UB-K60 ±5 19
Other* – 1 to 45 –
* Set for the setting values not displayed in the
cutter blade type when cutting the media that
is hard to cut.
To return to continue the settings of other
tool condition number, return to step 3 by
pressing the [1] key.
7 Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
8 Press the POSITION ( ) key and increase or decrease the
setting value.
9 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3).
10 Press the [COND/TEST] key.
It will return to default screen.