GRAPHTEC CE6000 SERIES - Page 63

2-33
Normal mode
Operation
Supplement
Name of the media assigned in "Cutting
Plotter controller" is displayed as the
CONDITION No. name.
CONDITION No. can also be changed from
READY status. See "Change the Cutting
Condition"
P.3-6
.
1 Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION ( ) key (CANCEL) .
2 Press the [1] key.
CONDITION No. selection screen is displayed.
3 Press the POSITION ( ) key and select the setting
(CONDITION No.).
4 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3)
5 Press the [COND/TEST] key.
It will return to default screen.