GRAPHTEC CE6000 SERIES - Page 170

7-5
7 Press the [2] key (START).
Overcut length for START setting screen is displayed.
Supplement
Setting range is from 0.0 mm to 0.9 mm.
8 Press the POSITION ( ) key and increase or decrease the
setting value.
9 Conrm the setting value, and press the POSITION ( ) key
(PREVIOUS).
Length for overcut START is selected and return to OVERCUT setting
screen.
10 Press the [3] key (END).
Overcut length for END setting screen is displayed.
Supplement
Setting range is from 0.0 mm to 0.9 mm.
11 Press the POSITION ( ) key and increase or decrease the
setting value.
12 Conrm the setting value, and press the POSITION ( ) key
(PREVIOUS).
Length for overcut END is selected and return to OVERCUT setting
screen.
13 Repeat steps 3 to 12 as necessary to set multiple tool
CONDITION No.
Supplement
It will return to CONDITION screen (2/3)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
14 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION setting screen (2/3).
15 Press the [COND/TEST] key.
It will return to default screen.