GRAPHTEC CE6000 SERIES - Page 159

5-42
2 Press the POSITION ( ) key and move the tool carriage
to the area to start scanning of the registration mark.
Supplement
Left gure is for 4POINTS. Size and position
of the registration scan start area is same for
2POINTS or 3POINTS.
Registration mark scan start area
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Move the tool inside
this area
Move the tool inside
this area
100mm
100mm
Point 1 (point to make
origin point)
Point
4
Point
2
Point
3
Point
4
Point
2
Point
3
Point 1 (point to make
origin point)
Supplement
It will return to ARMS SETTING screen
(1/4) without scanning when you press the
POSITION ( ) key (CANCEL).
3 Conrm the position of the tool, and if it is OK, press the
[ENTER] key.
Registration marks are scanned. Following message is displayed when
completed.
4 Press the POSITION ( ) key and move the tool carriage
to the next area to start scanning of the registration mark.
Supplement
Left gure is for 4POINTS. Size and position
of the registration scan start area is same for
2POINTS or 3POINTS.
Registration mark scan area
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Move the tool inside
this area
Move the tool inside
this area
Point 1 (point to make
origin point)
Point 1 (point to make
origin point)
Point 4 Point 2
Point 3
Point 3
Point 4 Point 2