GRAPHTEC CE6000 SERIES - Page 113

4-12
6 Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
Supplement
Number of copies can be set from 1 to 100,
as much as it can t in the media set on the
printer.
The initial value for the number of copies is
always 1.
7 Press the POSITION ( ) key and increase or decrease the
setting value.
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or
set the media that is big enough to copy.
8 Conrm the setting and press the POSITION ( ) key
(PREVIOUS).
Number of copies will be selected, and it will return to COPY mode
screen.
Supplement
Copy interval can be set when MEDIA
CHANGE MODE is turned off.
Copy space can be set from 1.0 mm to 10.0
mm.
This setting is maintained even if the power
is turned off.
9 Press the [3] key (COPY SPACE).
COPY SPACE setting screen is displayed.
10 Press the POSITION ( ) key and increase or decrease the
setting value.
11 Conrm the setting and press the POSITION ( ) key
(PREVIOUS).
Copy space will be selected, and it will return to COPY MODE screen.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times
until the buffer memory is cleared. It can be
copied again after exchanging the media by
pressing [COPY] key.
12 Conrm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as
specified.