GRAPHTEC CE6000 SERIES - Page 138

5-21
Supplement
It will return to ARMS SETTING screen (3/4)
after setting the sensor level to default when
you press the [2] key (DEFAULT).
6 Press the [1] key (SCAN).
Following message is displayed.
Supplement
The tool carriage will move faster when the
[FAST] key is pressed simultaneously with the
POSITION key.
7 Press the POSITION ( ) key and move the tool carriage
to the area to start scanning of the registration mark.
Feed direction of media
Align the tool to this area
Registration mark scan area
Supplement
It will return to ARMS SETTING screen (3/4)
without changing the settings when you
press the [4] key (CANCEL).
It may not scan correctly even after the
adjustment depending on the condition of
the media. See "Manual Position Adjust"
P.6-3
if the detection does not complete
properly.
8 Conrm the position of the tool, and if it is OK, press the
[ENTER] key.
Registration mark is scanned, and sensor level is adjusted. It will return
to ARMS SETTING screen (3/4) once the adjustment is completed.
9 Press the [PAUSE/MENU] key.
It will return to default screen.