5-36
Operation
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-5
for loading the media.
1 Load the media with registration marks (2POINTS) plotted.
2 Set the MARK SCAN MODE to ARMS, and POINTS to
2POINTS.
P.5-7
Setting MARK SCAN Mode and Numbers
Supplement
It is not necessary to set the MARK DISTANCE
when it is adjusted manually.
3 Set the shape and size of the registration mark, mark
distance, distance adjust mode, offset, paper-weight, sensor
level, scan position adjustment, etc., as needed.
P.5-11
Setting Shape (Pattern) of Registration Mark
P.5-12
Setting Registration Mark Size
P.5-14
Setting Mark Distance
P.5-16
Setting Distance Adjustment Between the
Registration Mark
P.5-18
Setting Offset Between the Registration Mark and
Cutting Origin Points
P.5-20
Adjusting the Sensor Level
P.5-22
Manually Adjusting the Sensor Level (Threshold
Value)
P.7-17
Setting Paper-Weight
4 Press the [PAUSE/MENU] key.
MENU screen is displayed.
5 Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
Steps are different from here depending if it is going to move
to registration mark automatically to scan the registration
mark, or if it is going to move manually to scan. See next
section.
P.5-40
Adjust Automatically
P.5-41
Adjust Manually
To Next Page
Loading...
