GRAPHTEC CE6000 SERIES - Push Roller Sensor Enable;Disable

10-5
Enabling/Disabling the Push Roller Sensors (PUSH ROLLER SENSOR)
This function enables or disables the push roller sensors that detect the width of the media.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2 Press the POSITION ( ) key (ADV.).
ADVANCE setting screen (1/2) is displayed.
3 Press the POSITION ( ) key.
ADVANCE setting screen (2/2) is displayed.
4 Press the [1] key (PUSH ROLLER SENSOR).
PUSH ROLLER SENSOR setting screen is displayed.
Supplement
If "DISABLED" is selected, push roller
detection is not performed.
It will not generate error even if the inner push
rollers are not on the grit rollers when the
"INSIDE DISABLED" is selected.
5 Press the [1] key (ENABLED), the [2] key (INSIDE
DISABLED), or the [3] key (DISABLED).
Supplement
When "DISABLE" has been set, the home
sensor position is not detected, so depending
on the data, a position error could occur.
6 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ADVANCE setting screen.
7 Press the [PAUSE/MENU] key.
It will return to the default screen.