GRAPHTEC CE6000 SERIES - Page 210

11-5
Enabling/Disabling the ":" and ";" Commands (COMMAND ":",";")
If the rst part of the data is lost when the GP-GL command is set, these commands may be having an adverse
effect. In this case, set the ":" and ";" commands to DISABLED.
Operation
Supplement
Perform the settings in Normal mode.
1 Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
2 Press the POSITION ( ) key (I/F).
INTERFACE setting screen (1/2) is displayed.
3 Press the POSITION ( ) key.
INTERFACE setting screen (2/2) is displayed.
4 Press the [2] key (COMMAND ":",";").
COMMAND ":",";" setting screen is displayed.
5 Press the [1] key (ENABLED) or the [2] key (DISABLED).
6 Conrm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACE setting screen (2/2).
7 Press the [PAUSE/MENU] key.
It will return to the default screen.