GRAPHTEC CE6000 SERIES - Page 254

A-14
Menu items Setting items Initial value
INTERFACE COMMAND AUTO
HP-GL ORIGIN POINT LOWER LEFT
HP-GL MODEL EMULATED 7586
GP-GL STEP SIZE 0.100 mm
RS232C (SWITCHING SETTING NUMBERS) No.1
RS232C: FORWARDING CONDITION
BAUD RATE/BIT LENGTH/PARITY/
HANDSHAKE
RS232C NO.1: 9600/8/NONE/HARD
RS232C NO.2: 9600/7/EVEN/HARD
RS232C NO.3: 9600/8/EVEN/XONXOFF
RS232C NO.4: 9600/8/EVEN/XONXOFF
"COMMAND "":"","";""" ENABLED
"COMMAND ""W""" TOOL UP
CIRCLE RESOLUTION DEFAULT
ADVANCE MOVE STEP 0.1 mm
LANGUAGE SELECTION Select when initially turning on power
LENGTH UNIT Select when initially turning on power
MEDIA SENSOR ENABLED
PUSH ROLLER SENSOR ENABLED
FAN POWER NORMAL
BEEP FOR KEY OPE. ON
TEST NO SETTINGS –
TOOL
SETTING
CONDITION NO. 1 TOOL CONDITION NO. CONDITION NO. 1
TOOL CB09U
SPEED 30
FORCE 14
ACCELERATION 2
TANGENTIAL EMULATION OFF
OVERCUT (START) 0
OVERCUT (END) 0
DISTANCE ADJUST OFF
INITIAL DOWN FORCE 0
CONDITION NO. 2 TOOL CONDITION NO. CONDITION NO. 2
TOOL PEN
SPEED/FORCE/ACCELERATION 30/12/2
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
CONDITION NO. 3 TOOL CONDITION NO. CONDITION NO. 3
TOOL CB09U
SPEED/FORCE/ACCELERATION 30/12/2
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
CONDITION NO. 4 TOOL CONDITION NO. CONDITION NO. 4
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/17/1
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
CONDITION NO. 5 TOOL CONDITION NO. CONDITION NO. 5
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/17/2
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
CONDITION NO. 6 TOOL CONDITION NO. CONDITION NO. 6
TOOL CB09U
SPEED/FORCE/ACCELERATION 10/22/2
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
CONDITION NO. 7 TOOL CONDITION NO. CONDITION NO. 7
TOOL CB09U-K60
SPEED/FORCE/ACCELERATION 30/17/2
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
CONDITION NO. 8 TOOL CONDITION NO. CONDITION NO. 8
TOOL CB15U
SPEED/FORCE/ACCELERATION 5/30/1
Same as Condition No. 1 from TANGENTIAL
EMULATION to INITIAL DOWN FORCE.
Same as Condition No. 1
* The initial values of setting items is subject to change.