1-13
3 Attach a media stocker to each of the left and right stand
sides with Five socket head cap screws, using the Allen
wrench. Mount the media stockers so that each one
protrudes directly above the longer of the two stand foot
lengths.
Install the media guide bar using the socket head cap screws
(two on each side).
Stand foot
Stand sides
Socket head cap screw
Media stocker
Media stocker
Media guide bar
Socket head cap screw
Socket head
cap screw
Long
CAUTION
Please be careful not to get your hands pinched
or stuck when you secure the machine.
Supplement
Check that all of the screws used for
fastening have been tightened. The media
may not be fed correctly if even one of the
screws is loose.
When installing the plotter, make sure that
there are no objects in its vicinity. Leave a
clear space of at least 300 mm around the
plotter.
4 Mount the plotter on the stand by inserting the positioning
pins on the stand into the positioning holes on the underside
of the plotter. Fasten with four socket head cap screws (two
on each side), using the Allen wrench.
Positioning pin
Socket head
cap screw
Socket head
cap screw
Caster stoppers
5 Tighten the socket head cap screws loosely fastened in Step 2.
To Next Page
Loading...
