GRAPHTEC CE6000 SERIES - Page 47

2-17
Supplement
The media must always be positioned over
the media sensor.
See "2.4 Aligning the Push Rollers"
P.2-19
about the position of the push rollers.
See "2.4 Aligning the Push Rollers"
P.2-19
for information about push roller hold-down
force.
3 Position the media and the push rollers to correspond with
the width of the media.
Use the 3 push rollers to push down the sides and center of
the media. Use the grit roller position guide and make sure
the push rollers are on top of the grit rollers.
Use the grit roller position guide to make sure the push
rollers are set on top of the grit rollers.
You can adjust the center push roller's hold-down force.
Grit roller position guide
Push roller
Media sensor
Push roller
Grit roller
Push roller
(The center push roller is not on top of the grit roller.) (The center push roller is near the edge.)
(The push roller is on top of the grit roller.) (The push roller is on top of the grit roller.)
4 Pull out the front media under the media guide bar.
Media guide bar