GRAPHTEC CE6000 SERIES - Page 50

2-20
When Feeding Long-axis Media (at least 2 meters)
Position the push rollers at least 5 mm inside the edges of the media.
Push roller
Media
5 mm 5 mm
For minimum width media
Make sure that all push rollers are on the long right grit roller.Use the left side of the grit roller as a starting point
and then set the push rollers so that they're on both sides of the media.
The CE6000-40/60 can take media of 55 mm or more, and the CE6000-120 can take media of 90 mm* or more.
* Set the middle push rollers (except the right and the left side of push rollers) hold-down force to "OFF" (weak)
when the all push rollers are on the right side grit roller (wide) with the CE6000-120.
Media sensor
Media
Grit roller
CE6000-40/60
Push roller
Media sensor
Media
Grit roller
CE6000-120
Push roller
CAUTION
The media must be at least 125 mm in length in media feed direction.
The media must always be positioned over the media sensor.