2-46
To make 3 cuts with set value and ±1 of set value
Operation
1 Load the media for test cutting in the plotter.
2 Press the [COND/TEST] key in the default screen.
In Normal mode, CONDITION screen (1/3) is displayed.
In Simple mode, CONDITION screen (1/5) is displayed.
CONDITION screen
(Simple mode)
CONDITION screen
(Normal mode)
Supplement
It will return to CONDITION screen by
pressing the [4] key (CANCEL) .
Change cutter offset settings in Normal
mode.
3 Press the POSITION ( ) key (CUT TEST).
CUT TEST screen is displayed.
CONDITION screen
(Simple mode)
CONDITION screen
(Normal mode)
Supplement
Pushing the [POSITION] and [FAST] keys
simultaneously will move the tool carriage faster.
4 Press the POSITION (
) key the tool carriage to the
location you wish to perform the test cutting.
CAUTION
When the [1] key (FORCE) is pressed, the tool
carriage will start moving, so take care not to
cut your ngers.
Supplement
Test cut patterns can have their cut order and
force changed as shown below.
Cut Order
+1 0 -1
5 Press the [1] key (FORCE).
3 cutting test patterns are cut, with current FORCE in the center, and 1
each of FORCE increased and decreased for 1.
6 Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
CAUTION
When the [2] key (CUTTER OFFSET) is
pressed, the tool carriage will start moving, so
take care not to cut your ngers.
7 Press the [2] key (CUTTER OFFSET). (Normal mode only)
3 cutting test patterns are cut, with current CUTTER OFFSET in the
center, and 1 each of CUTTER OFFSET increased and decreased for 1.
8 Press the [ENTER] key after completion.
It will return to CUT TEST menu screen.
9 Press the [4] key (CANCEL).
It will return to CONDITION screen.
10 Press the [COND/TEST] key.
It will return to default screen.
To Next Page
Loading...
