What to do if GRAPHTEC FC8600 registration marks cannot be scanned?
If registration marks cannot be scanned properly on your Graphtec Plotter because of scan errors, and the cutting media is floating, press down the cutting media.
Why is media jumping out of my GRAPHTEC FC8600 Plotter?
If the Graphtec Plotter media jumps out to the forward side, the wrong type of media may be selected. Check the media type setting: "SHEET", "ROLL-1 REAR SET", or "ROLL-2 REAR SET."
Why my GRAPHTEC Plotter fails to scan scratchy registration marks?
If registration marks cannot be scanned properly on your Graphtec Plotter because of scan errors, and the registration marks are scratchy, rewrite the registration mark lines more clearly.
Why is media curling on my GRAPHTEC FC8600 Plotter?
If the Graphtec Plotter media curls up at the corners and fine cut characters peel off, and the blade is extended too far, adjust the blade length.
Why is my GRAPHTEC FC8600 Plotter cutting on the grit roller imprint?
If your Graphtec Plotter is cutting on the grit roller imprint, the cutting width is widened. Set the setting of the cutting width to 0.
How to fix registration marks scan error due to media color on GRAPHTEC FC8600 Plotter?
If registration marks cannot be scanned properly on your Graphtec Plotter because of scan errors, and the color of the cutting media is not black, adjust the cencor level. If this does not help, use black registration marks.
Why is my GRAPHTEC FC8600 blade skipping?
If the Graphtec Plotter blade skips and does not completely cut lines that should be solid, and straight cut lines seem to wobble, and the cutting speed is too high, lower the speed setting.
Lists safety warnings to prevent fatal or serious injury if ignored.
Provides steps for assembling the plotter stand and related parts.
Explains how to connect the plotter to a computer via interface cables.
Describes the nomenclature and structure of cutter pens.
Details the procedure for attaching a tool (cutter pen or plotter pen) to the plotter.
Guides on loading roll media and sheet media into the plotter.
Describes the steps for powering on the plotter.
Explains the functions of lamps and keys on the control panel.
Allows setting tool, speed, force, and acceleration for 8 different conditions.
Guides on performing test cuts to optimize cutting conditions.
Introduces ARMS function for scanning registration marks and its purpose.
Covers setting MARK SCAN mode, numbers, shape, size, and distance.
Explains methods to adjust position using ARMS with 2, 3, or 4 points.
Details the method for manually adjusting position, including axis tilt and distance.
Describes how to set USB, Network (LAN), and RS-232C interfaces.
Provides precautions for daily plotter operation and cleaning.
Guides on how to replace the cutter blade.
Details the procedure for replacing the cross cut unit.
Provides troubleshooting for common issues like media wobbling or tool carriage errors.
Offers solutions for errors related to registration mark scanning.
Addresses issues with cut quality, such as rounded corners or dull blades.
Lists and explains error messages related to the ARMS system.
Guides on performing a self-diagnostic test of sensors and switches.
Lists key technical specifications of the FC8600 Series plotters.
General| Power Supply | AC 100-240V, 50/60Hz |
|---|---|
| Maximum Cutting Speed | 1485 mm/s |
| Mechanical Resolution | 0.005 mm |
| Repeatability | ±0.1 mm |
| Interface | USB, Ethernet, Serial (RS-232C) |
| Media Types | Reflective film |
| Programmable Resolution | 0.025 mm (0.001 in) |
| Command Sets | HP-GL, GP-GL |
| Blade Type | Supersteel blade |
| Optional Accessories | Stand, Basket |
To Next Page
