GW Instek GSP-9300 - Page 231

ADVANCED OPERATION
229
Note
The arrow keys can be used to move the cursor to
the desired step when in the Sequence menu.
Add Delay to
Sequence
The delay function adds a delay between steps.
1. Press Delay Time[F2]> and enter the delay time.
Range:
100ms ~ 10s
2. Press
Enter
to add the delay time to the
sequence editor.
 The delay time will be inserted as a step.
Note
The arrow keys can be used to move the cursor to
the desired step.
Pause Sequence
The Wait to Go function is used to pause a
sequence until Continue[F1] is pressed. This is
useful for observing measurements before
moving onto the next step.
1. Press Wait to Go[F3]>
Enter
.
 Wait to Go will be inserted as a step.
2. When a sequence is running, Press Continue[F1]
to resume running the sequence.