96-8100 1-15-96
192
PARAMETERS
SERVICE
MANUAL
VF-SERIES
T SUBROUTINE Reserved for future use.
SPIN Y ENCDR For Lathe only. When enabled, spindle encoder input is to the Y-axis.
REV CONVEYOR Reverses the direction of the chip conveyor.
M27-M28 CONVYR Usually the chip conveyor motor and direction relays are attached to the user
relays M21 M22. When this bit is set, the control expects to see the conveyor
hooked up to M27 and M28.
LOPH A ONLY When (0) three discrete inputs are used to detect power phase loss. When (1)
only LOPH A is used to detect phase loss.
GREEN BEACON When (1) user relay M25 is used to flash a beacon. If the control is in a reset
state, the beacon will be off. If the control is running normally, the beacon will
be steadily on. If the control is in a M00, M01, M02, M30 feedhold, or single
block state, then the beacon will flash.
RED BEACON When (1) user relay M26 is used to flash a beacon. The beacon flashes if the
control is experiencing an alarm or emergency stop condition.
CONVY DR OVRD When (1) the conveyor will continue to run with the door open. When (0) the
conveyor will stop when the door is open, but will resume when the door is
closed. For safety it is recommended that the bit be set to (0).
DSBL CLNT IN If set to 1 low coolant input will not be used.
DSC INP PR Discrete pallet rotate/part ready; inputs enabled if set to 1.
RMT TOOLS RLS If set to 1, allows use of remote tool release button on spindle head.
FLOPPY ENABL If set to 1, enables the optional floppy drive.
TCR KEYPAD If set to 1, enables tool changer restore button on keypad.
MCD RLY BRD If set to 1, adds 8 additional relays, for a total of 40.
TSC ENABLE When set to 1, DSBL CLNT IN bit is ignored, and TSC will operate. When set to
zero, the control functions normally.
AUX JOG NACC Does not allow accumulation on auxiliary axis jog.
ALISM PRGRST Alias M codes during program restart.
DSBL JOG TST Disables the encoder test for the jog handle.
AIR DR @ M24 On horizontal mill, air door uses M24. When set to zero, air door output is M23
and pallet ready light is at output K19.
ACC FEED LIM Setting 85 limits feed in circles.
SPNDL NOWAIT When (1), the machine will not wait for the spindle to come up to speed imme
diately after an M03 or M04 command. Instead, it will check and/or wait for the
spindle to come up to speed immediately before the next interpolated motion is
initiated. This bit does not affect rigid tapping or the TSC option.
UNDEFINED
To Next Page
Loading...
Need help?
General
