96-8100 1-15-96
34
ALARMS
HAAS AUTOMATION, INC.
SERVICE
MANUAL
VF-SERIES
335 Z-axis Disabled same as 333.
336 A-axis Disabled Parameters have disabled this axis. Must enable A-axis to program it or remove programming
of A-axis. The A-axis can be disabled permanently by Parameter 43 or temporarily by Setting
30.
337 Line Referenced By Subprogram is not in memory, or P code is incorrect.
P, Not Found
338 Invalid IJK and XYZ There is a problem with circle definition; check your geometry.
in G02 or G03
339 Multiple Codes Only one M, X, Y, Z, A, Q, etc. allowed in any block or two G codes in the same group.
340 Cutter Comp Begin Select cutter comp earlier.
With G02 or G03
341 Cutter Comp End Disable cutter comp later.
With G02 or G03
342 Cutter Comp Path Geometry not possible. Check your geometry with the HELP page.
Too Small
343 Display Queue A block exists that is too long for displaying queue. Shorten title block.
Record Full
344 Cutter Comp With Cutter Comp only allowed in XY plane (G17).
G18 and G19
345 Diff Step Ratio Parameters 5 and 19 must be same value.
On G17 Plane
346 Diff Step Ratio Parameters 5 and 33 must be same value.
On G18 Plane
347 Diff Step Ratio Parameters 19 and 33 must be same value.
On G19 Plane
348 Illegal Spiral Motion Linear axis path is too long. For helical motions, the linear path must not be more than the
length of the circular component.
349 Prog Stop W/O Information message only. Fix or Ignore.
Cancel Cutter Comp
350 Cutter Comp Look There are too many non-movement blocks between motions when cutter
Ahead Error comp is being used. Remove some intervening blocks.
351 Invalid P Code Software error. Call your dealer.
To Next Page
Loading...
Need help?
General
