1-15-96 96-8100
HAAS AUTOMATION, INC.
35
TABLE OF CONTENTS
ALARMS
SERVICE
MANUAL
VF-SERIES
352 Aux Axis Power Off Aux B, C, U, V, or W axis indicate servo off. Check auxiliary axes. Status from control was OFF.
353 Aux Axis No HomeA ZERO RET has not been done yet on the aux axes. Check auxiliary axes. Status from control
was LOSS.
354 Aux Axis Aux axes not responding. Check auxiliary axes and RS-232 connections.
Disconnected
355 Aux Axis PositionMismatch between machine and aux axes position. Check aux axes and
Mismatch interfaces. Make sure no manual inputs occur to aux axes.
356 Aux Axis Travel Limit Aux axes are attempting to travel past their limits.
357 Aux Axis DisabledAux axes are disabled.
358 Multiple Aux Axis Can only move one auxiliary axis at a time.
359 Invalid I, J, or K In G12 Check your geometry with the HELP page.
or G13
360 Tool Changer Disabled Check Parameter 57. Not a normal condition for VF Series CNC Mill.
361 Gear Change Disabled Check Parameter 57. Not a normal condition for VF Series CNC Mill.
362 Tool Usage Alarm Tool life limit was reached. To continue, reset the usage count in the Current Commands
display and press RESET.
363 Coolant Locked Off Override is off and program tried to turn on coolant.
364 No Circ Interp Only rapid or feed is allowed with aux axes.
Aux Axis
367 Cutter Comp G01 cannot be done with tool size.
Interference
368 Groove Too Small Tool too big to enter cut.
369 Tool Too Big Use a smaller tool for cut.
370 Pocket Definition Check geometry for G150.
Error
371 Invalid I, J, K, OR Q Check G150.
372 Tool Change In Tool change not allowed while canned cycle is active.
Canned Cycle
373 Invalid Code in DNC A code found in a DNC program could not be interpreted because of
restrictions to DNC.
To Next Page
Loading...
Need help?
General
