96-8100 1-15-96
36
ALARMS
HAAS AUTOMATION, INC.
SERVICE
MANUAL
VF-SERIES
374 Missing XYZA in G31 skip function requires an X, Y, Z, or A move.
G31 or G36
375 Missing Z or H in G37 G37 auto offset skip function requires H code, Z value, and tool offset
enabled. X, Y, and A values not allowed.
376 No Cutter Comp In Skip Skip G31 and G37 functions cannot be used with cutter compensation.
377 No Skip in Graph/Sim Graphics mode cannot simulate skip function.
378 Skip Signal Found Skip signal check code was included but skip was found when it was not expected.
379 Skip Signal Not Found Skip signal check code was included but skip was not found when it was expected.
380 X, Y, A, or G49 G37 may only specify Z-axis and must have tool offset defined.
Not Allowed in G37
381 G43 or G44 Not Auto work offset probing must be done without tool offset.
Allowed in G36 or G136
382 D Code Required in G35 A Dnn code is required in G35 in order to store the measured tool diameter.
383 Inch Is Not Selected G20 was specified but settings have selected metric input.
384 Metric Is Not Selected G21 was specified but settings have selected inches.
385 Invalid L, P, or R G10 was used to changes offsets but L, P, or R code is missing or
Code In G10 invalid.
386 Invalid Address Format An address A¼Z was used improperly.
387 Cutter Comp Not If block buffering has been limited, Cutter comp cannot be used.
Allowed With G103
388 Cutter Comp Not Coordinates cannot be altered while cutter comp is active. Move G10 outside of cutter comp.
Allowed With G10 enablement.
389 G17, G18, G19 Planes of rotation cannot be changed while rotation is enabled.
Illegal in G68
390 No Spindle Speed S code has not been encountered. Add an S code.
391 Feature Disabled An attempt was made to use a control feature not enabled by a parameter bit. Set the parameter
bit to 1.
392 B Axis Disabled Same as 336.
393 Invalid Motion In Rigid Tapping can only be in the Z minus G74 or G84 direction.
G74 or G84 Make sure that the distance from the initial position to the commanded Z depth is in the minus
direction.
To Next Page
Loading...
Need help?
General
