Microlab
®
STAR Service Manual
8.5.4 Replacement
• Remove Left Deck Panel to access Autoload Board, see section 7.4.2 Deck
Panels on page 7-7.
• Before the Autoload Board is replaced, print a hardcopy of all Data from the
Board by using Service Software.
• Disconnect all cables and unscrew Autoload Board.
Screw P/N 400656 5 x
8.5.5 Remounting:
• Instructions are basically the reverse of those for disassembly.
• Data may restored (if copied from replaced Autoload PCB).
• With Service Software:
• Check Autoload settings
• Check for correct Firmware
8.5.6 Adjustment
• It is highly recommended that you run the AUTOLOAD
AUTOADJUSTMENT.MCR to generate new calibration values for Autoload drive.
To Next Page
Loading...
