Microlab
®
STAR Service Manual
6-15
6.3.1 Pipetting Channels degrees of freedom
ttention: Exercise great care when loosening or tightening the
Channel Fixing screws, as excessive torque tension has a direct
effect on the ball bearings of the slides and in fact may damage
them - then proper positioning is no longer possible.
Channel Fixing Screws:
First loosen both locking set screws which are located just above
the upper and underneath the lower fixing screw.
Then slightly loosen the 2 fixing screws for a moving in X-Axis
and tilting around Y-Axis.
Torque Tension:
fixing screws M4: 300 cNm, or fixing screws M3: 110 cNm
locking set screws M2: 50 cNm
Channel to Y Slide Fixing Screws:
By slightly loosening the 4 fixing screws, tilting around X-Axis is
enabled.
Torque Tension fixing screws:
M3 x 8 P/N 420013: 110 cNm, or M2 x 8 P/N 400604: 50 cNm
To Next Page
Loading...