Microlab
®
STAR Service Manual
2-10
Technical Specifications (continued)
General Note on Drive Specifications
1
:
The User Interface is the Master where all units are 0.1 mm in length and volumes
are 0.1 µl.
The master transfers the User's software commands to its slaves and therefore you
do not have to know drive resolutions when calculating positions, volumes, etc.
2.2.1 Technical Status of ML STAR Instrument
Technical Status contains all technical data specific to each instrument. It must be
updated by the Service Technician whenever any modifications are made.
Technical Status information is stored on the EEPROM of components of ML STAR
Instrument and may viewed, changed and printed via service software only.
It is highly recommended that a copy of the current Technical Data Sheet be held by
the Service Technician for his own reference.
1
see in section 12.4.3 Firmware Reference Guides on page 12-19
To Next Page
Loading...
