Microlab
®
STAR Service Manual
4-5
4.2.2 Unpacking the instrument
The Microlab
®
STAR comes in a box on a wooden pallet. Examine the packaging for
signs of damage. If there is any damage, contact the shipper or your Hamilton
representative immediately.
Lift off the top and surrounding cover.
Note: the Form "Unpacking Instructions" will be found inside the ML STAR
packaging on top of the Instrument. The Instructions will mainly guide through the
unpacking procedure as described below.
The Instructions form describes packing the ML STAR Instrument as well.
For general packing Instructions see section 5 Disassembly on page 5-1.
Remove all Panels from top of accessories boxes, then remove accessory boxes
and examine the Instrument and all parts against damage.
Leave the protective material in place until the Microlab
®
STAR has been placed in
its permanent position.
Attention: Do not turn Barcode Reader by hand as this may damage the DC Motor.
If the Barcode Reader must be turned, use the Service Software, or remove the
outer covering to access Gear, and turn on cogwheel or belt instead.
See section 7.9 Auto Load drive on page 7-37.
To Next Page
Loading...
