Hamilton Microlab STAR - Maintenance Checklist

Microlab
®
STAR Service Manual
12-11
12.2.2 Maintenance Checklist
Decontamination and cleaning
of all exposed surfaces:
OK REMARKS
Deck

______________________________________
Docking Station

______________________________________
Loading trays
31

______________________________________
Instrument Covers

______________________________________
Pipetting Arm housing

______________________________________
Autoload ribbon
32

______________________________________
Spillage trays

______________________________________
Air filter, replace if necessary

______________________________________
Uncover Pipetting Arm
Check Cable connections

______________________________________
Check and clean Y- Spindles

______________________________________
On Pipetting Heads:
Replace CO-RE O-Rings

______________________________________
Check Stop Disk’s

______________________________________
Check Tip ejection Tubes

______________________________________
On Pipetting Heads clean and only slightly grease:
Squeezer Spindle
33

______________________________________
Dispensing Spindle

______________________________________
Clean and slightly grease guide shafts of:
X-Guides Pipetting Arm

______________________________________
X-Guide Autoload
34

______________________________________
31
Microlab
®
-STAR Instrument with Autoload Option only
32
dito
33
only with brass nuts
34
Microlab
®
-STAR Instrument with Autoload Option only