Get card reader type and descripon. They are read-only.
Default Authencaon Mode
View the default card reader authencaon mode.
Fingerprint Capacity
View the maximum number of available ngerprints.
Exisng Fingerprint Number
View the number of existed ngerprints in the device.
4.
Click Advanced and you can congure more parameters.
Enable Card Reader
Enable the funcon and you can operate the funcons
below on the card reader.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of
main board according to the card reader parameters.
Generally, adopts the default sengs.
Max. Interval When Entering PWD
When you inpung the password on the card reader, if the
interval between pressing two digits is larger than the set
value, the digits you pressed before will be cleared
automacally.
Tampering Detecon
Enable the an-tamper detecon for the card reader.
Fingerprint Recognion Level
Select the
ngerprint recognion level from the drop-down
list.
Fingerprint
Recognion Interval
Select the ngerprint recognion interval from the drop-
down list.
5.
Click OK.
6.
Oponal: Click Copy to, and then select the card reader(s) to
copy the parameters in the page to the selected card reader(s).
Congure Parameters for Alarm Output
Aer adding the access control device, if the device links to alarm
outputs, you can
congure the parameters.
Before You Start
Add access control device to the client, and make sure the device
supports alarm output.
Steps
1.
Click Access Control → Advanced
Funcon → Device
Parameter to enter access control parameter conguraon
page.
2.
In the device list on the le, click to expand the door, select
an alarm input and you can edit the alarm input's parameters
on the right.
3.
Set the alarm output parameters.
Name
Edit the card reader name as desired.
Alarm Output
Acve Time
62
To Next Page
Loading...
Need help?
General
