HIKVISION DS-K1T804A Series User Manual

Create a dismiss code which can be used to stop the buzzer
of the card reader (by entering the dismiss code on the
keypad).
Note
•
The duress code, super code, and dismiss code should be
dierent.
•
The duress code, super password, and the dismiss code
should be dierent from the authencaon password.
•
The length of duress code, super password, and the dismiss
code is according the device, usually it should contains 4 to 8
digits.
5.
Click OK.
6.
Oponal: Click Copy to , and then select the door to copy the
parameters in the page to the selected doors.
Note
The door's status duraon sengs will be copied to the
selected door as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card
reader parameters.
Steps
1.
Click Access Control → Advanced
Funcon → Device
Parameter .
2.
In the device list on the
le, click to expand the door, select a
card reader and you can edit the card reader's parameters on
the right.
3.
Edit the card reader basic parameters in the Basic
Informaon
page.
Note
•
The displayed parameters may vary for dierent access
control devices. There are part of parameters listed as
follows. Refer to the user manual of the device for more
details.
•
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less
than the set value, the card swiping is invalid. You can set it
as 0 to 255.
Alarm of Max. Failed
Aempts
Enable to report alarm when the card reading aempts
reach the set value.
Max. Times of Card Failure
Set the max. failure aempts of reading card.
Card Reader Type/Card Reader Descripon
61

HIKVISION DS-K1T804A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804A Series
Category	IP Access Controllers
Language	English