HIKVISION DS-K1T804A Series User Manual

Aer adding the access control device, you can set the device log
uploading mode, and create EHome account via wired network.
Set Log Uploading Mode
You can set the mode for the device to upload logs via EHome
protocol.
Steps
Note
Make sure the device is not added by EHome.
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3.
Select an access control device in the device list and enter
Network → Uploading Mode .
4.
Select the center group from the drop-down list.
5.
Check Enable to enable to set the uploading mode.
6.
Select the uploading mode from the drop-down list.
-
Enable N1 or G1 for the main channel and the backup
channel.
-
Select Close to disable the main channel or the backup
channel
Note
•
The main channel and the backup channel cannot enable N1
or G1 at the same me.
•
N1 refers to wired network and G1 refers to GPRS.
7.
Click Save.
Create EHome Account in Wired Communicaon Mode
You can set the account for EHome protocol in wired
communicaon mode. Then you can add devices via EHome
protocol.
Steps
Note
•
This funcon should be supported by the device.
•
Make sure the device is not added by EHome.
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3.
Select an access control device in the device list and enter
Network → Network Center .
4.
Select the center group from the drop-down list.
5.
Select the Address Type as IP Address or Domain Name.
6.
Enter IP address or domain name according to the address
type.
7.
Enter the port number for the protocol.
67

HIKVISION DS-K1T804A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T804A Series
Category	IP Access Controllers
Language	English