6000-X10800 requires at least two fan trays and three (in the country or region where the stand-
ard voltage is 110V, at least six) 220V AC power modules or four -48V DC power modules.
SG-6000-X10800 supports the following expansion modules:
l SCM: SCM-300
l SSM: SSM-300
l QSM: QSM-300
l IOM: IOM-P100-300, IOM-P40-300
l SIOM: SIOM-P40-300, SIOM-P100-300, SIOM-P100D-300
l SWM: SWM-300
Notes:
l For SG-6000-X10800, when there is no QSM-300 installed, you can install
IOM or SIOM to process QoS (make sure that the device has installed the
iQoS license). If you install the IOM to process iQoS, the iQoS does not sup-
port the shaping mode. If you install the SIOM to process iQoS, iQoS is the
same as the iQoS realized by installing QSM.
l When is device is installed with both QSM and IOM, QSM takes effect pref-
erentially to process iQoS.
l For more information about the expansion modules, see Expansion Module
Introduction.
l For more information about installing expansion modules on SG-6000-
X10800, see Installing Expansion Modules of SG-6000-X10800. For more
information about removing expansion modules of SG-6000-X10800, see
Replacing an Expansion Module of SG-6000-X10800.
10
Preface
To Next Page
Loading...
Need help?
General