Hioki 3560 - Page 102

90
────────────────────────────────────────────────────
7.4 Message Reference
────────────────────────────────────────────────────
Synta
x
:SENSecheck data
dat
a
ON/OFF (Character data)
Exampl
e
Transmission
:SENS ON
Broken-line detection is turned on
for the SENSE line of the
measurement leads.
Synta
x
:SENSecheck?
Respons
e
synta
x
(If headers are ON)
:SENSECHECK data
(If headers are OFF)
data
Exampl
e
(If headers are ON)
Transmission
:SENS?
Response
:SENSECHECK ON
(If headers are OFF)
Transmission
:SENS?
Response
ON
Synta
x
:VRANge data
dat
a
-50 to 50 (Numerical value data)
Exampl
e
Transmission
:VRAN 5
Voltage range is set to 5 V range.
F
unctio
n
SENSE line break check for
measurement leads turns on or off.
F
unctio
n
This command returns the setting
for SENSE line break check for
measurement leads in ON/OFF
character data (data) format.
F
unctio
n
Sets the voltage range.
Note
s
･ If another range is set, an executio
n
error occurs.
･ If resistance measurement mode is
active, an execution error occurs.
:SENSecheck
■ Sets the SENSE line break check for measurement leads.
:SENSecheck?
■ Queries on/off status of the SENSE line break check for measurement leads.
:VRANge
■ Sets the voltage range.