Hioki 3560 - Page 61

49
────────────────────────────────────────────────────
6.3 Measurement by External Control Terminal and External Output Terminal
────────────────────────────────────────────────────
1
0
H
L
1
0
1
0
【State】
Chuck
【Output】
NG
【Input】
MANU
【Output】
【Output】
EOC
Hi,IN,Lo
FAST MEDIUM SLOW
Frequency: 50 Hz Approx.95 ms Approx.795 ms Approx.1.92 s
Frequency: 60 Hz Approx.80 ms Approx.660 ms Approx.1.60 s
(3) Measurement Using MANU Function
Connect object to be measured to measurement lead.
Measurement error alarm signal(NG) is disengaged.
MANU
―――――――――――
signal is output after time to stabilize.
Waiting time（response time）is as follows depending on sampling.
This value applies in the case of pure resistance. Waiting time
varies depending on type of object to be measured.
Adjust it after measurement and when value fluctuates, enter
larger value.
When MANU
―――――――――――
signal is input, it outputs latest data from completed
measurement at the time.
Remove resistance being measured.
Outputs measurement error signal (NG). Repeats processes from .