Hioki 3560 - Page 88

76
────────────────────────────────────────────────────
7.4 Message Reference
────────────────────────────────────────────────────
Synta
x
:CSET:RPARameter data1, data2
dat
a
Rang
e
(Ω)
data1 data2
30 m 0 to 31.000E-3 0 to 31.000E-3
300 m 0 to 310.00E-3 0 to 310.00E-3
3 0 to 3.1000 0 to 3.1000
30 0 to 31.000 0 to 31.000
300 0 to 310.00 0 to 310.00
3k 0 to 3.1000E+3 0 to 3.1000E+3
*Numerical value dat
a
Exampl
e
Transmissio
n
:CSET:RRAN 30E‑3;:RPAR 10.123E
‑
3, 25.567E‑3
The comparator function executes
in the 30 mΩ range under the
conditions: the upper limit is
25.567 mΩ and the lower limit is
10.123 mΩ.
Synta
x
:CSET:RPARameter?
Respons
e
synta
x
(If headers are ON)
:CSET:RPARAMETER data1, data2
(If headers are OFF)
data1, data2
Exampl
e
(If headers are ON)
Transmission
:CSET:RPAR?
Response
:CSET:RPARAMETER 25.567E‑
3,10.123E‑3
(If headers are OFF)
Transmission
:CSET:RPAR?
Response
25.567E‑3,10.123E‑3
F
unctio
n
This command sets the resistance
range of the comparator specified by
the :CSET:NUMBer command. The
upper and lower limits are
determined automatically; the
smaller value is defined as the lowe
r
limit and the larger value is defined
as the upper limit.
Note
s
If the set range deviates from the
range specified by the :CSET:RRANge
command, an execution error occurs
.
F
unctio
n
This command returns the set
resistance range of the comparator
specified by the :CSET:NUMBer
command in NR3 numeric data
(data) format.
:CSET:RPARameter
■ Sets the upper and lower limits for comparator resistance.
:CSET:RPARameter?
■ Queries the upper and lower limits for comparator resistance.