Hioki 3560 - Page 87

75
────────────────────────────────────────────────────
7.4 Message Reference
────────────────────────────────────────────────────
Synta
x
:CSET:MODe?
Respons
e
synta
x
(If headers are ON)
:CSET:MODE data
(If headers are OFF)
data
Exampl
e
(If headers are ON)
Transmission
:CSET:NUMB 20;MOD?
Response
:CSET:MODE RV
(If headers are OFF)
Transmission
:CSET:NUMB 20;MOD?
Response
RV
Synta
x
:CSET:NUMBer data
dat
a
1 to 30 (Numerical value data)
Exampl
e
Transmission
:CSET:NUMBER 1
Comparator 1 is set.
Synta
x
:CSET:NUMBer?
Respons
e
synta
x
(If headers are ON)
:CSET:NUMBER data
(If headers are OFF)
data
Exampl
e
(If headers are ON)
Transmission
:CSET:NUMB?
Response
:CSET:NUMBER 1
(If headers are OFF)
Transmission
:CSET:NUMB?
Response
1
F
unctio
n
･ This command selects resistance
measurement mode or resistance
and voltage measurement mode for
the comparator specified by the
:CSET:NUMBer command.
F
unctio
n
This command is used to select the
number of comparator to be set.
Note
s
If the set numeric data falls outside
the range 1 to 30, an execution erro
r
occurs.
F
unctio
n
This command returns the currentl
y
set comparator number as a NR1
value (1 to 30).
:CSET:MODe?
■ Queries for the measurement mode set for the comparator.
:CSET:NUMBer
■ Selects the number of comparator to be set.
:CSET:NUMBer?
■ Queries the number of comparator to be set.