Hioki 3560 - Page 86

74
────────────────────────────────────────────────────
7.4 Message Reference
────────────────────────────────────────────────────
Synta
x
:CSET:BEEPer data
dat
a
Resistance measurement mode:
OFF/IN/HL character data
Resistance and voltage
measurement mode:
OFF/PASS/FAIL character data
Exampl
e
Transmission
:CSET:BEEP IN
The setting is made so that the
buzzer sounds when the
comparator result is IN.
Synta
x
:CSET:BEEPer?
Respons
e
synta
x
(If headers are ON)
:CSET:BEEPER data
(If headers are OFF)
data
Exampl
e
(If headers are ON)
Transmission
:CSET:BEEP?
Response
:CSET:BEEPER IN
(If headers are OFF)
Transmission
:CSET:BEEP?
Response
IN
A setting is made so that the
buzzer for the specified comparato
r
number sounds when the
comparator result is IN.
Synta
x
:CSET:MODe data
dat
a
R/RV (Character data)
Exampl
e
Transmission
CSET:NUMB 10;MODe R
Comparator number 10 is set to
resistance measurement mode.
F
unctio
n
This command sets the buzzer for
the comparator specified by the
:CSET:NUMBer command.
Note
s
Data is selected according to the
mode specified by the :CSET:MODE
command. Two modes are available:
resistance measurement mode and
resistance and voltage measuremen
t
mode.
F
unctio
n
This command returns the buzzer
setting for the comparator specified
by the :CSET:NUMBer command in
OFF/IN/HL character data format
(resistance measurement mode) or
OFF/PASS/FAIL character data
format (resistance and voltage
measurement mode). The data
format is data.
F
unctio
n
This command selects either
resistance measurement mode or
resistance and voltage measuremen
t
mode for the comparator specified b
y
the :CSET:NUMBer command.
Note
s
If character data other than R or RV
is set, an execution error occurs.
:CSET:BEEPer
■ Sets the buzzer for comparator determination.
:CSET:BEEPer?
■ Queries the buzzer setting for comparator.
:CSET:MODe
■ Sets for the measurement mode set for the comparator.