Hitachi G200 - Replacing a Fan on a Host Port Expansion Chassis; Blocking a Fan on a Host Port Expansion Chassis

Replacing a fan on a host port expansion chassis
Blocking a fan on a host port expansion chassis
Before you begin
• Confirm that the storage system power is turned on.
• Use the Dump tool to collect the storage system configuration information.
• The red ALM LED is on at the fan to be replaced.
Procedure
1. Start the maintenance utility.
2. Click Hardware > Channel Board Box.
3. Click the FAN tab.
4. To display the most recent status of the fan click Refresh.
5. Check the status of the fan is Warning.
Replacing a fan on a host port expansion chassis
Procedure
1. Remove the front bezel.
136 Replacing a fan
Service Guide for VSP Gx00 and VSP Fx00 Models