Hitachi G200 - Attaching the Front Bezel to a Dense Intermix Drive Tray

Attaching the front bezel to a dense intermix drive tray
Procedure
1. Use the provided key to unlock the front bezel.
2. Insert the tabs on the left-front side of the storage system into the tab
holes on the front bezel.
3. Push the right side of the bezel until it engages with the ball catch on the
front of the storage system to secure the bezel.
4. Use the provided key to lock the front bezel.
Note: To avoid damaging the key, verify the key is fully inserted
into the lock before turning it.
5. Remove the key from the lock.
Note: To avoid damaging the lock, align the groove of the key with
the positioning mark on the lock before removing the key.
Replacing storage system components 93
Service Guide for VSP Gx00 and VSP Fx00 Models