Hitachi G200 - CBLH Rear Panel

Number Item Description
Amber: LAN reset switch was
pressed.
9
LAN-RST switch Use only when instructed by
customer support.
10
STATUS LED (for BKMF) Green: Charging of the battery
in the backup module is
complete.
Red: Backup module can be
removed.
Blink red one time: Main
battery failure.
Blink red two times: Backup
battery failure.
Blink red three times: Both
batteries failed or preventive
maintenance replacement of
batteries can run.
Off: Battery is not mounted,
battery-mounting failure
occurred, or firmware is being
upgraded. Off is normal status
for configurations without
batteries (for example,
BKMF-10 and BKMF-20).
CBLH rear panel
The following table describes the definitions of the CBLH controller rear panel
LEDs.
46 Hardware description
Service Guide for VSP Gx00 and VSP Fx00 Models