Hitachi G200 - Blocking the Controller

Blocking the controller
Procedure
1. Start the maintenance utility.
2. Click Hardware > Controller Chassis.
3. In the Controller Chassis window, click the CTLs tab.
4. To display the most recent status of the controller, click Refresh.
5. Confirm the status of the controller to be replaced is Warning or Failed.
6. Click Replace (Type Change) and select the controller you want to
replace.
7. When the Replace Controller Board (Type Change) window opens,
verify the controller shown in the window is the one to be replaced, and
then click Block.
162 Replacing a controller
Service Guide for VSP Gx00 and VSP Fx00 Models