Hitachi G200 - Replacing a Drive for a CBSS or SFF Drive Tray

6. If you receive a message about the encryption environment setting is
applied, click Close, and then back up the encryption key after
completing the drive-replacement procedure.
7. In the Controller Chassis Drive Box window, check that the drive
status is Blocked. If the drive status is Copying, wait for it to change to
Blocked.
Replacing a drive for a CBSS or SFF drive tray
The drive numbering in a chassis is #0 to #23, from left to right.
Replacing a drive 111
Service Guide for VSP Gx00 and VSP Fx00 Models