Hitachi G200 - Blocking a Pcie Switch Board

Blocking a PCIe switch board
Before you begin
• Confirm that the storage system power is turned on.
• Use the Dump tool to collect the storage system configuration information.
• The red STATUS LED is on at the PCIe switch board to be replaced.
• Dropping the PCIe switch board can cause injury. Be aware of the red line
on the top of the controller when sliding out the controller past this mark
and always keep a firm hold on the PCIe switch board.
Procedure
1. Start the maintenance utility.
2. Click Hardware > Channel Board Box.
3. Click the SWPKs tab.
4. To display the most recent status of the PCIe switch board, click
Refresh.
286 Replacing a PCIe switch board
Service Guide for VSP Gx00 and VSP Fx00 Models