Removing and installing cache memory
Before you begin
• Wear a wrist strap connected to the storage system to prevent part
failures caused by static electricity. Do not remove the wrist strap until you
finish the procedure.
• The controller is removed from the storage system.
Procedure
1. Open the air guide.
2. Pull the lever outward.
3. Holding both ends of the cache memory, pull out the cache memory from
the socket.
Note: Do not exert pressure on the cache memory. Otherwise, you
can damage the printed-circuit board.
174 Replacing a controller
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
