Hitachi G200 - Replacing a Small Form-Factor Pluggable (SFP+) for a NAS Module; Checking the SFP+ for a NAS Module

4. Connect the optical fibre cable to the new SFP. Check that the cable latch
clicks and the cables are surely connected.
5. Confirm that the red PORT LED on the front end module is off.
6. In the Controller Chassis or Channel Board Box window, confirm that
the status of the replacement SFP is Normal.
If necessary, click Refresh at the top-right of the window to update the
status in the window.
7. Log out and close the Maintenance Utility window.
Replacing a small form-factor pluggable (SFP+) for a NAS
module
This section describes the procedure for replacing a SFP+ for the NAS
module.
Checking the SFP+ for a NAS module
Before you begin
Procedure
1. Start the maintenance utility.
2. In the Maintenance Utility window, click Hardware > Controller
Chassis.
3. Click the CHBs tab.
4. To display the most recent status of the SFP+, click Refresh.
218 Replacing a small form-factor pluggable (SFP)
Service Guide for VSP Gx00 and VSP Fx00 Models