Hitachi G200 - Replacing SAS Cables Connected to a CBSS or CBSL Controller

Replacing SAS cables connected to a CBSS or CBSL
controller
Replacing SAS cables for a CBSS or CBSL controller requires you to block a
controller before replacing the cables.
Procedure
1. Start the maintenance utility.
2. In the Maintenance Utility window, Hardware --> Controller
Chassis.
3. Click the CTLs tab.
4. To display the most recent status of the controller, click Refresh.
5. Check the status of the controller.
6. After checking that the appropriate controller has been selected, click
Block.
7. When the Replace Controller Board window opens, verify that the
appropriate controller is shown in the window, and then click Block.
Replacing a SAS cable 237
Service Guide for VSP Gx00 and VSP Fx00 Models