Hitachi G200 - Blocking a Front End Module

Blocking a front end module
Procedure
1. Start the maintenance utility.
2. In the Maintenance Utility window, click Hardware > Controller
Chassis or Hardware > Channel Board Box.
3. Click the CHBs tab.
4. To display the most recent status of the front end module, click Refresh.
5.
Confirm that the status of the front end module to be replaced is
Warning.
6. Click the front end module to be replaced, and then click Replace.
7. Click Block.
206 Replacing a front end module
Service Guide for VSP Gx00 and VSP Fx00 Models