3. Holding the lower right part of the bezel, gently pull the key toward you
and disengage the right side of the bezel from the ball catch.
Note: To prevent any damages to the bezel, do not open the bezel
more than 45 degrees when disengaging the front bezel.
4. Disengage the front bezel from the left tabs and then remove the bezel.
Attaching the front bezel to a CBSS or CBSLAttaching the front bezel
to an FMDAttaching a front bezel to an SFF, LFF, or FMD
Procedure
1. Use the provided key to unlock the front bezel.
2. Insert the tabs on the left-front side of the storage system into the tab
holes on the front bezel.
3. Use the provided key to lock the front bezel.
Note: To avoid damaging the key, verify the key is fully inserted
into the lock before turning it.
4. Remove the key from the lock.
Note: To avoid damaging the lock, align the groove of the key with
the positioning mark on the lock before removing the key.
Removing the front bezel from a DBS or DBL drive tray
Procedure
1. Use the provided key to unlock the bezel.
90 Replacing storage system components
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
