Hitachi G200 - Blocking a Pcie Module

Blocking a PCIe module
Before you begin
• Confirm that the storage system power is turned on.
• Use the Dump tool to collect the storage system configuration information.
• The red STATUS LED is on at the PCIe module to be replaced.
Procedure
1. Start the maintenance utility.
2. Click Hardware > Controller Chassis.
3. Click the PECBs tab.
4. To display the most recent status of the PCIe module click Refresh.
5. Confirm that the status of the PCIe module to be replaced is Warning.
6. Select the PCIe module to be replaced, and click Replace.
7. Click Block.
280 Replacing a PCIe module
Service Guide for VSP Gx00 and VSP Fx00 Models