Replacing the NAS module
Procedure
1. Remove the cables connected to the NAS module. Mark the port from
where the cable was removed.
2. Loosen the two blue screws that secure the NAS module and open the
levers.
3. Hold the NAS module with both hands, keep it straight, and gently pull it
forward. Keep the NAS module level to avoid shocking any parts.
Note: The heat sinks can be hot on a NAS module that is removed
from the storage system. Avoid touching these hot parts when
removing the NAS module.
306 Replacing a NAS module
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
